Bulletins

Multiple vulnerabilities affecting SIMATIC S7-PLCSIM V5.4 could allow an attacker with local access to the system to craft special project files that may lead to denial-of-service attacks. Siemens recommends specific workarounds and mitigations.

Some firmware versions of the SCALANCE and RUGGEDCOM devices listed below are affected by a vulnerability in the SSH authentication that could allow an attacker to cause a Denial-of-Service under certain conditions. Siemens has released an update for the SCALANCE SC-600 family and recommends to update to the latest version. …

A Denial-of-Service vulnerability was found affecting the ARP protocol on older firmware versions of the SCALANCE W780 and W740 (IEEE 802.11n) devices. Siemens recommends to update to the latest version.

The installation of SIMARIS configuration causes insecure folder permissions that could allow vertical privilege escalation. Siemens is preparing updates and recommends specific countermeasures until fixes are available.

A vulnerability in the SIMATIC WinCC Graphics Designer tool could allow an attacker that has physical access to a machine running the software to get access to the user’s private password-protected pictures. Siemens has released an update for SIMATIC WinCC and recommends to update to the latest version. Siemens recommends …

A vulnerability in several SCALANCE X devices could allow an unauthenticated attacker with network access to an affected device to perform a denial-of-service. Siemens has released an update for SCALANCE X-200IRT and recommends to update to the latest version. Siemens recommends specific countermeasures for products where updates are not, or …

The products listed below contain a vulnerability that could allow remote attackers to affect the availability of the devices under certain conditions. The underlying TCP stack can be forced to make very computation expensive calls for every incoming packet which can lead to a Denial-of-Service. Siemens has released an update …