SIEMENS CERT
10/08/2019
Several industrial devices are affected by two vulnerabilities that could allow an attacker to cause a Denial-of-Service condition via PROFINET DCP network packets under certain circumstances. The precondition for this scenario is a direct layer 2 access to the affected products. PROFIBUS interfaces are not affected. Siemens has released updates …
SIEMENS CERT
10/08/2019
Several industrial products are affected by a vulnerability that could allow an attacker to cause a Denial-of-Service condition via PROFINET DCP network packets under certain circumstances. Precondition for this scenario is a direct Layer 2 access to the affected products. Siemens has released updates for several affected products, is working …
SIEMENS CERT
10/08/2019
The latest update for SIMATIC WinCC fixes a vulnerability in the SIMATIC WinCC DataMonitor web application of the affected products that allows to upload arbitrary ASPX code. An attacker has to be authenticated with a valid user account. The vulnerability is only relevant for scenarios where access via the web …
SIEMENS CERT
10/08/2019
A vulnerability in affected devices could allow an attacker to perform a denial-of-service attack if a large amount of specially crafted UDP packets are sent to the device.. Siemens has released updates for several affected products, and recommends that customers update to the new version. Siemens is preparing further updates …
SIEMENS CERT
09/10/2019
Security researchers published information on vulnerabilities known as ZombieLoad and Microarchitectural Data Sampling (MDS). These vulnerabilities affect many modern processors from different vendors to a varying degree. Several Siemens Industrial Products contain processors that are affected by the vulnerabilities.
SIEMENS CERT
09/10/2019
The latest update for SIMATIC WinCC fixes multiple vulnerabilities. The most severe could allow an attacker to execute arbitrary commands on an affected system under certain conditions. Siemens has released updates for several affected products, and recommends that customers update to the new version. Siemens is preparing further updates and …
SIEMENS CERT
09/10/2019
A vulnerability has been identified in SINETPLAN that could allow local users to execute arbitrary application commands without proper authentication. Siemens provides a solution that fixes the vulnerability and recommends that users apply the update.
SIEMENS CERT
09/10/2019
The latest update for SINEMA Remote Connect Server fixes four vulnearbilities in the web interface. Two of the vulnerabilities are missing protection mechanisms for password guessing and for Cross Site Request Forgery attacks, the third one is a missing authentication check, and the fourth one could allow an attacker with …